Installing an angle stop cork is a straightforward process that can be done with basic plumbing tools and knowledge. Here is a step-by-step guide to help you through the installation process:

Shut Off the Main Water Supply: Before beginning the installation, ensure that the main water supply to the house is turned off to prevent any water leakage.

Prepare the Area: Clear the area around the installation site, removing any debris or obstacles. This will give you ample space to work and ensure a clean installation.

Remove the Old Valve: If you are replacing an old valve, use a wrench to loosen and remove it. Be cautious to avoid damaging the existing plumbing.

Install the New Angle Stop Cork: Place the new angle stop cork onto the water supply pipe. Ensure that it is aligned correctly and secure it by tightening the compression nut with a wrench. Avoid over-tightening, as this can cause damage.

Connect the Supply Line: Attach the supply line from the fixture to the outlet side of the angle stop cork. Tighten the connection securely.

Turn On the Water Supply: Gradually turn on the main water supply and check for any leaks. If there are no leaks, your installation is complete.

In summary, installing an angle stop cork is a manageable task that can improve the functionality and reliability of your plumbing system. By following these steps, you can ensure a successful and leak-free installation.